Kramer VP-773A

VP-773A - Using the Embedded Web Pages
61
61
9.1.3 Auto Switching
Click the Auto Switching button to open the Auto Switching window (see Figure 45).
The Auto Switching window lets you set the Main and PiP scanning mode
separately to:
 Off to disable scanning
 Scan mode to scan through the inputs in search of a valid input signal.
In the scan mode you can select which of the inputs will be included in the
scan (see Figure 46) and also change the order of the scanned inputs (see
Figure 47)
 Last Connected mode to immediately switch to the latest valid input signal
connected (for HDMI and DP inputs only)
Note that in case the last connected valid input signal is disconnected, the VP-
773A will switch to the previous last-connected valid-input signal, and then to
the input before that and so on until the last disconnected inputs, and then a
“No Signal” screen will appear
Figure 45: The Routing & Scaling Page –
Auto Switching Window (Main Tab)
Figure 46: The Routing & Scaling Page –
selecting the Inputs to Scan (PiP Tab)