Kramer VP-773A - The Audio Menu

VP-773A - The OSD Menu
27
27
6.3 The Audio Menu
Figure 19: Audio Menu
Setting
Function
Volume
Set the input/output volume level [dB], see Figure 20 E. Set the:
Input Volume [dB] – to adjust the audio input level
Output Volume [dB] – to adjust the audio output level
The maximum output volume can be pre-limited via the Web pages (see Section 9.6.2).
When setting the volume level, once the slider reaches the maximum defined by the pre-
limiter, a “Volume is pre-limited” message appears on screen.
The output audio level can also be set via the + and – buttons on the front panel buttons
(when not in the OSD mode) and/or the IR remote control transmitter buttons (see
Section 8.4)
Note that when set to MUTE (see Section 6.8), changing the output level unmutes the audio
signal.
Mic1 Volume [dB] – to adjust the Microphone 1 audio level
Mic2 Volume [dB] – to adjust the Microphone 2 audio level
Balance
Set the balance [ratio] E
Treble
Set the treble [dB] E
Bass
Set the bass level [dB] E
Mic Effects
For Mic 1, set the:
Mic1 Talkover Depth [%] – to determine the decrease of the audio level during
microphone 1 takeover (press + to further decrease the talkover audio output
level; press – to lessen the talkover output audio decrease level) E
Mic1 Talkover Trigger [dB] – to determine the microphone 1 threshold level
that triggers the audio output-level decrease E
Mic1 Mix [dB] – set to 1 to enable the Talkover mode or set to any other value
to decrease the Mic1 volume without changing the Line out and Mic2 volume
levels.
In the Mix mode, set the:
Line Mix [dB] – to decrease of the line out volume level without changing the
Mic 1 and Mic 2 volume levels