6. Connect the HDMI 1 OUT connector to an HDMI acceptor (for example, an
LCD display).
You can also connect the HDMI OUT 2 output (not shown in Figure 4)
7. Connect the HDBT RJ-45 connector to a receiver (for example, the Kramer
TP-580Rxr).
8. Connect the AUDIO LINE OUT Terminal Block connector to a balanced
audio acceptor and the S/PDIF OUT RCA connector to a digital audio
acceptor (not shown in Figure 4).
9. Connect the SPKR OUT block connector to a pair of loudspeakers, by
connecting the left loudspeaker to the “L+” and the “L-” terminal block
connectors, and the right loudspeaker to the “R+” and the “R-” terminal block
connectors. Do not Ground the loudspeakers.
10. If required, you can connect a PC and/or controller to the:
RS-232 terminal block (see Section 8.3.2)
Ethernet connector (see Section 8.3.3)
11. Connect the power cord (not shown in Figure 4).
To Next Page
Loading...
