▪ In the Last connected mode, the last connected input is switched to the selected
output (you can remove an input from the priority list, see Removing and Adding an
Input on page 27):
Figure 21: Auto Switching Mode – Last Connected Mode
4. Click Save.
Priority and Last Connected settings are indicated in the Routing Settings page as
follows:
▪ The input priority-order appears. under the output (see HDMI 1 Figure 22).
▪ Last Connected (LC) appears under output (see HDMI 2 in Figure 22).
Figure 22: Auto Switching Mode – Priorities List
Auto-switch settings are complete.
To Next Page
Loading...
