Kramer VS-62HA - Connecting the Remote Contact-Closure Switches and Leds; Figure 6: Internet Protocol Properties Window

16
VS-62HA - Connecting the VS-62HA
Figure 6: Internet Protocol Properties Window
7. Click OK.
8. Click Close.
5.2.2 Connecting the Ethernet Port via a Network Hub or Switch
You can connect the Ethernet port of the VS-62HA to the Ethernet port on a
network hub or using a straight-through cable with RJ-45 connectors.
5.3 Connecting the Remote Contact-Closure Switches
and LEDs
You can connect up to six remote, contact-closure switches and LEDs per
output to control the VS-62HA remotely. These switches replicate the Input
selection buttons on the front panel of the VS-62HA.