Kramer VS-62HA

VS-62HA - Protocol 3000 Commands
61
15.3 Switching/Routing Commands
Note: Use the ROUTE command in preference to legacy AUD, VID, and AV
commands (see below).
Command
Description
Type
Permission
AFV
Set/get audio follow video mode
Switching
End User
AUD
Set/get audio switch state
Switching
End User
ROUTE
Set/get layer routing
Routing
End User
VID
Set/get video switch state
Switching
End User
Command - AFV
Command Type - Switching
Command Name
Permission
Transparency
Set:
AFV
End User
Public
Get:
AFV?
End User
Public
Description
Syntax
Set:
Set audio follow video/audio breakaway
mode
#AFV␠ afv_mode␍
Get:
Get audio follow video mode status
#AFV?␍
Response
~nn@AFV␠ afv_mode␍␊
Parameters
afv_mode - front panel AFV mode
0/afv - sets the unit to the audio-follow-video switching mode
1/brk - sets the unit to the audio breakaway switching mode
Response Triggers
Notes
When the unit moves from breakaway to audio follow video switching mode, all audio switch settings are
reset according to the video switch settings.