Kramer VS-62HA

66
VS-62HA - Protocol 3000 Commands
15.5 Audio Commands
These commands are used by audio devices running Protocol 3000.
Command
Description
Type
Permission
AUD-LVL
Set/Get audio level in specific amplifier stage
Audio
End user
AUD-SIGNAL?
Get audio input signal status
Audio
End user
MUTE
Set/get audio mute
Audio
End User
Command - AUD-SIGNAL
Command Type - Audio
Command Name
Permission
Transparency
Set:
-
-
-
Get
AUD-SIGNAL?
End User
Public
Description
Syntax
Set:
-
-
Get:
Get audio input signal status
# AUD-SIGNAL?␠inp_id␍
Response
~ nn@ AUD-SIGNAL␠ inp_id, status ␍␊
Parameters
Inp_id - input number (1 .. max input number)
status - 0 - OFF (no signal)
1 - ON (signal present
Response Triggers
After execution, response is sent to the com port from which the Get was received
Response is sent to all com ports if audio status state was changed on any input
Notes