Kramer VS-62HA

VS-62HA - Principles of Operation
19
6.3 EDID Operation
The VS-62HA has a default EDID (see Section 13) stored on all inputs. This
EDID can be exchanged for either:
 A custom EDID which is uploaded to one or more inputs using Protocol
3000 commands (see Section 15)
–OR–
 The EDID of a display device connected to an output by using either the
front panel buttons (see Section 7.2), a Protocol 3000 command, or the
Web pages
The EDID is non-volatile and the last valid EDID is used when the device is
powered up.
6.4 Step-in Functionality
The VS-62HA can function as a step-in switcher when connected to a suitable
HDMI transmitter, (for example, the SID-X3N), using the correct HDMI cable
with HEC support.
Use the Web pages (see Section 9.1.2) to assign remote device button actions.
The default button actions are shown in the following table. Up to three buttons
can be active at the same time.
Command
Action
Echo
Allows a connected controller to be programmed to perform a variety
of tasks triggered by the user buttons, such as, room control, (lights,
screen, and so on)
Out1
Step in current input to Output 1
Out2
Step in current input to Output 2