Kramer VS-62HA - System Commands

VS-62HA - Protocol 3000 Commands
53
15.2 System Commands
Command
Description
Type
Permission
AV-SW-MODE
Set/get auto switch mode
System
End user
BAUD
Set/get protocol serial port baud rate
System
End User
DISPLAY?
Get output HPD status
Switch
End User
HDCP-MOD
Set/get HDCP mode
System
Administrator
HDCP-STAT?
Get HDCP signal status
System
End user
LDFW
Load new firmware file
System
End User Internal SW
LOCK-FP
Set/get front panel lock
System
Administrator
NAME
Set/get machine (DNS) name
System
Administrator
NAME-RST
Reset machine name to factory default (DNS)
System
Administrator
PRIO
Set/get input priority
System
Administrator
SIGNAL?
Get input signal lock status
System
End User
Command - AV-SW-MODE
Command Type - System
Command Name
Permission
Transparency
Set:
AV-SW-MODE
End user
Public
Get:
AV-SW-MODE?
End user
Public
Description
Syntax
Set:
Set input auto switch mode (per output)
# AV-SW-MODE␠layer,output_id,mode␍
Get:
Get input auto switch mode (per output)
# AV-SW-MODE?␠layer,output_id␍
Response
~ nn@AV-SW-MODE␠layer,output_id,mode␍␊
Parameters
layer – see Section 18.14 Layer Enumeration
output_id - 1….num of system outputs
mode - 0 - manual
1 - priority switch
2 - last connected switch
Response Triggers
Notes