VS-62HA - Principles of Operation
6 Principles of Operation
This section describes the operating theory of the VS-62HA and includes:
Automatic signal detection (see Section 6.1)
Input switching modes (see Section 6.2)
EDID operation (see Section 6.3)
6.1 Automatic Signal Detection
The VS-62HA can automatically detect the presence of a video signal on an
input based on the presence of a video sync or clock signal.
6.2 Input Switching Modes
6.2.1 Manual Mode
In Manual switching mode, routing is performed according to the front panel
button selection or according to the remote command selection.
6.2.2 Automatic Mode
Automatic switching can be performed in either of the following ways:
Input priority. Upon detection of an active input, the input with the
highest priority is automatically selected. Input priority is from the lowest
input number (1) to the highest (6)
Last Connected. The device automatically selects the most recently
connected input. Should this source become inactive, the device
automatically switches to the last connected input that was active. When
turning the device on and more than one input is active, the input with the
highest priority is selected
If a manual selection is made when the device is in Automatic mode, the device
enters Manual Override mode. The manually selected input remains selected
as long as it is active. When a manually selected input becomes inactive, the
device returns to Automatic mode.
To Next Page
Loading...
