Kramer VS-62HA

54
VS-62HA - Protocol 3000 Commands
Command - BAUD
Command Type - System
Command Name
Permission
Transparency
Set:
BAUD
Administrator
Public
Get:
BAUD?
Administrator
Public
Description
Syntax
Set:
Set protocol serial port baud rate
#BAUD␠ baud_rate␍
Get:
Get protocol serial port baud rate
(Option 1 - for current baud rate,
Option 2 - for list of supported baud
rates)
Option 1: #BAUD?␍
Option 2: #BAUD?␠baud_param␍
Response
~nn@BAUD␠baud_rate␍␊
Option 1: ~nn@BAUD␠current_baud_rate␍␊
Option 2: ~nn@BAUD␠baud_rate1, baud_rate2,...␍␊
Parameters
baud_rate - 9600 / 115200 / else - new baud rate to set
current_baud_rate - 9600 / 115200 / else - current protocol serial port baud rate
baud_param - 0 - get the list of supported baud rates
baud_rate1, baud_rate2, … - list of supported baud rates
Response Triggers
Notes
The new defined baud rate is stored in the EEPROM and used when powering up
Default baud rate is 115200 (on factory reset)
Only works with devices supporting this command (if ERR 002 is returned, the default baud rate is used)