Kramer VS-62HA - Page 61

56
VS-62HA - Protocol 3000 Commands
Command - HDCP-STAT
Command Type - System
Command Name
Permission
Transparency
Set:
-
-
-
Get:
HDCP-STAT?
End User
Public
Description
Syntax
Set:
None
-
Get:
Get HDCP signal status
#HDCP-STAT?␠ stage,stage_id␍
Response
Set / Get: ~ nn@HDCP-STAT␠ stage,stage_id,mode␍␊
Parameters
stage – input/output (see Section 18.2 Stage)
stage_id - number of chosen stage (1.. max number of inputs/outputs)
actual_status - signal encryption status - valid values ON/OFF (see Section 18.20 HDCP Types)
Response Triggers
Response is sent to the com port from which the Set (before execution) / Get command was received
Response is sent to all com ports after execution if HDCP-STAT was set by any other external control
device (button press, device menu and similar) or HDCP mode changed
Notes
On output – sink status
On input – signal status