Kramer VS-62HA - Page 68

VS-62HA - Protocol 3000 Commands
63
Command - ROUTE
Command Type - Routing
Command Name
Permission
Transparency
Set:
ROUTE
End User
Public
Get:
ROUTE?
End User
Public
Description
Syntax
Set:
Set layer routing
#ROUTE␠ layer, dest, src␍
Get:
Get layer routing
#ROUTE?␠layer, dest␍
Response
~ nn@ ROUTE␠ layer, dest, src ␍␊
Parameters
layer - see Section 18.14 Layer Enumeration
dest - * - ALL
x - disconnect, otherwise destination id
src - source id
Response Triggers
Notes
This command replaces all other routing commands
The GET command identifies input switching on Step-in clients
The SET command is for remote input switching on Step-in clients (essentially via by the Web)
Command - VID
Command Type - Switching
Command Name
Permission
Transparency
Set:
VID
End User
Public
Get:
VID?
End User
Public
Description
Syntax
Set:
Set video switch state
#VID␠in>out␍
Get:
Get video switch state
#VID?␠ out␍
Response
Set: ~nn@VID␠in>out ␍␊
Get: ~nn@VID␠in>out ␍␊
Parameters
in - input number or '0' to disconnect output
> - connection character between in and out parameters
out - output number or '*' for all outputs
Response Triggers
Notes
The GET command identifies input switching on Step-in clients
The SET command is for remote input switching on Step-in clients (essentially via by the Web)
This is a legacy command. New Step-in modules support the ROUTE command