KTM 200 DUKE 2021 - Preparing for Use; First Use and Engine Break-in

COMBINATION INSTRUMENT 7
33
7.26 Adjusting the shift speed RPM1
Condition
The motorcycle is stationary.
ODO > 1,000 km (621 m).
F01475-01
– Press the MODE button briefly and repeatedly until TRIP 1
appears on the display.
– Press the MODE button for 5 seconds.
The RPM1 display appears.
Info
The RPM1 display appears in the TRIP 1 display for
each menu by keeping the MODE button pressed.
RPM1 is the engine speed above which the shift warn-
ing light starts flashing.
The engine speed can be set at intervals of 50.
The shift speed RPM1 can only be set up to maximum
50 revolutions per minute below the shift speed RPM2.
– Adjust the speed with the MODE button and SET button.
Info
The MODE button increases the value.
The SET button decreases the value.
– Press the MODE button and SET button simultaneously.
The RPM1 display disappears and the set shift speed
RPM1 is adopted and saved.
7.27 Adjusting the shift speed RPM2
Condition
The motorcycle is stationary.
ODO > 1,000 km (621 m).
F01475-02
– Press the MODE button briefly and repeatedly until TRIP 2
appears on the display.
– Press the MODE button for 5 seconds.
The RPM2 display appears.
Info
The RPM2 display appears in the TRIP 2 display for
each menu by keeping the MODE button pressed.
RPM2 is the engine speed above which the shift warn-
ing light lights up.
The engine speed can be set at intervals of 50.
The shift speed RPM2 can only be set from a minimum
of 50 revolutions per minute above the shift speed
RPM1.
– Adjust the speed with the MODE button and SET button.
Info
The MODE button increases the value.
The SET button decreases the value.