SERVICE SCHEDULE 10
45
10.1 Additional information
Any further work that results from the compulsory work or from the recommended work must be ordered sepa-
rately and invoiced separately.
Different service intervals may apply in your country, depending on the local operating conditions.
Individual service intervals and scopes may change in the course of technical developments. The most up-to-date
service schedule can always be found on KTM Dealer.net. Your authorized KTM dealer will be happy to advise
you.
10.2 Required work
every 24 months
every 12 months
every 15,000 km (9,300 mi)
every 7,500 km (4,650 mi)
after 1,000 km (620 mi)
Preliminary work
Read out the fault memory using the KTM diagnostics tool. ○ ● ● ● ●
Main work
Check that the electrical system is functioning properly. ○ ● ● ● ●
Change the engine oil and oil filter, clean the oil screen. ( p. 90) ○ ● ● ● ●
Check the brake discs. ( p. 59) ○ ● ● ● ●
Check the front brake linings. ( p. 61) ○ ● ● ● ●
Check the rear brake linings. ( p. 64) ○ ● ● ● ●
Check the brake lines for damage and leakage. ○ ● ● ● ●
Check the front brake fluid level. ( p. 59) ○ ● ● ●
Check the rear brake fluid level. ( p. 62) ○ ● ● ●
Check the tire condition. ( p. 70) ○ ● ● ● ●
Check tire pressure. ( p. 71) ○ ● ● ● ●
Check the shock absorber and fork for leaks. ○ ● ● ● ●
Clean the dust boots of the fork legs. ( p. 50) ● ●
Check the chain, rear sprocket, and engine sprocket. ( p. 55) ● ● ● ●
Check the chain tension. ( p. 54) ○ ● ● ● ●
Check the coolant level. ( p. 81) ○ ● ● ● ●
Check that the radiator fan is functioning properly. ○ ● ● ● ●
Change the air filter, clean the air filter box. ● ●
Check that the throttle cables are undamaged, routed without sharp bends, and set cor-
rectly.
○ ● ● ● ●
Check the cables for damage and routing without sharp bends. ○ ● ● ● ●
Check the valve clearance, change the spark plug. ●
Change the front brake fluid. ●
Change the rear brake fluid. ●
Checking the steering head bearing for play. ○ ● ● ● ●
Check the headlight setting. ( p. 79) ○ ● ●
Final check: Check the vehicle is roadworthy and take a test ride. ○ ● ● ● ●
Read out the error memory after the test ride using the KTM diagnostics tool. ○ ● ● ● ●
Reset the service interval display. ○ ● ● ● ●
Final steps
To Next Page
Loading...
Need help?
General
