KTM 200 DUKE 2021 - Removing Rear Wheel

WHEELS, TIRES 14
67
B01391-11
–
Clean the thread of the wheel spindle and screw
2
.
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle
M8 25 Nm (18.4 lbf ft)
–
Position wheel speed sensor
3
in the hole.
–
Mount and tighten screw
4
.
Guideline
Screw, wheel speed
sensor holder
M6 8 Nm (5.9 lbf ft)
–
Mount and tighten screws
5
.
– Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
– Take the motorcycle off the front lifting gear. ( p. 50)
– Operate the front brake and compress the fork a few times
firmly.
The fork legs straighten.
–
Tighten screws
6
.
Guideline
Screw, fork stub M8 15 Nm (11.1 lbf ft)
Finishing work
– Remove the rear of the motorcycle from the lifting gear.
( p. 49)
14.3 Removing rear wheel
Preparatory work
– Raise the motorcycle with the rear lifting gear. ( p. 49)