65 / 81Issued: 22.04.2016 Version: Spez KR 20-3 V2
7 Transportation
Transportation The floor-mounted robot is transported using a crane or by fork lift truck. With-
out the transport frame, the ceiling-mounted robot can only be transported in
mounting position by fork lift truck. In the transport frame, transportation with
fork lift truck or crane is possible.
Transportation by
fork lift truck
For transport by fork lift truck (>>> Fig. 7-4 ), the fork slots must be properly
and fully installed. For installation on the ceiling, the robot can only be trans-
ported to the installation site using a fork lift truck. The transport frame has two
fork slots for lifting it with the forks of a fork lift truck.
The robot must be in the transport position.
Fig. 7-3: Transport dimensions, KR 20-3 C
1 Robot
2 Eyebolts
3 Transport frame for ceiling-mounted robot
4 Center of gravity
5 Fork slots
Use of unsuitable handling equipment may result in dam-
age to the robot or injury to persons. Only use authorized
handling equipment with a sufficient load-bearing capacity. Only transport
the robot in the manner specified here.
To Next Page
Loading...
