Safety Instructions and Warnings
8
User's guide
Check consignment
Transport the appliance to a suitable place and remove it from its packaging there. The oven may only be
assembled and installed by an electrician who complies with the respective specifi cations.
Check to ensure that the consignment is complete.
□ Check the appliance for any transport damage.
□ Contact our Customer Service if the consignment is incomplete or if the appliance shows any transport
damage.
CAUTION!
Never put a damaged appliance into operation!
2. Safety Instructions and Warnings
2.1. For connection and operation
□ Only KÜPPERSBUSCH appliance have been manufactured and tested for use under
a KÜPPERSBUSCH hob. Do not use other hobs.
□ Any handling or repair to the appliance, including replacement of the power cable,
should be carried out by authorised Technical Service Personnel using original spare
parts. Repairs or handling by others may damage the appliance or cause malfunc-
tioning that could be hazardous to your safety.
□ Statutory regulations and the connection specifications issued by the local power
supply company must be strictly observed.
□ The power supply to the appliance must be disconnected when the lamp is connected,
repaired or replaced. Disconnect the fuse or pull out the power plug.
□ Installation must guarantee full safety against any potential contact.
□ Changing the installation location of a plug and replacing the mains cable may only
be carried out by an electrician who complies with the respective specifications.
□ It is essential for the connection data (frequency and voltage) of the appliance to
comply with that of the mains electricity supply in order for the oven not to be dam-
aged. Compare this data when connecting the oven. If in any doubt, ask a qualified
electrician.
To Next Page
Loading...
Need help?
General
