Installation
54-0161
47
Installing Your Selected Satellites
To install your selected satellites as Satellite A and B, follow the
steps below.
1. Apply power to the ADCU.
2. Following the startup sequence, press the center
button until the “Control Antenna?” screen
appears.
3. Press the
ENTER button to access the Control
Antenna Mode.
4. Press the center button until the “Install Satellite?”
screen appears.
5. Follow the process shown in Figure 2-35 on the
following page to install your selected satellites. At
the end of the process, be sure to press the YES
button to restart the antenna.
Section 3, “Using the ADCU
Interface” on page 61
provides
complete details on the use of the
ADCU menus, including complete
antenna control details in
Section 3.8, “Control Antenna
Mode” on page 83.
Figure 2-33
Control Antenna Screen
Figure 2-34
Install Satellite Screen
To Next Page
Loading...
Need help?
General
