Preparation before Use
2-37
2
*1 This is displayed when the optional SSD is installed.
*2 The fax function only shows ECOSYS M6526cdn/ECOSYS M6526cdn Type B.
*3 The logged in user may not be able to configure some settings, depending on the permissions of the user.
*4 This is displayed when the optional Card Authentication Kit is installed.
NOTE: Here, information on the FAX settings has been omitted. For more information on using the FAX, refer
to the FAX Operation Guide.
Accessing Command Center RX
1
Launch your Web browser.
2
In the address or location bar, enter the machine's IP address or the host name.
Examples: https://192.168.48.21/ (for IP address)
https://MFP001 (if the host name is "MFP001")
The web page displays basic information about the machine and Command Center RX as well as their
current status.
NOTE: If the screen āThere is a problem with this website's security certificate.ā is displayed, configure the
certificate. For details on Certificates, refer to the Command Center RX User Guide.
You can also continue the operation without configuring the certificate.
3
Select a category from the navigation bar on the left of the screen. When you log in to the machine as an
administrator, you will see Device Settings, Function Settings, Network Settings, Security Settings,
and Management Settings.
Management
Settings
Configure the advanced management settings.
Job Accounting, Authentication, ID Card
*4
,
Notification/Report, History Settings, SNMP, Reset
ā -
Setting Description
Adminis-
trator
General
User
To Next Page
Loading...
Need help?
General
