Kyocera FS-1024MFP

Scanning Image to USB
OPERATION GUIDE 6-17
6
Adjusting Density
Use the procedure below to adjust the density when scanning the originals.
The table below shows the available settings.
The procedure for adjusting the density is explained below.
1 Press the Scan to USB key.
2 Press the U or V key to select [Store File].
3 Press the OK key. The basic screen appears.
4 Place the originals on the platen.
5 Press the Function Menu key. Function Menu
appears.
6 Press the U or V key to select [Density].
7 Press the OK key. Density appears.
8 Press the U or V key to select [Auto] or [Manual].
If you select [Manual], press the OK key, and then
select the density on the next screen.
9 Press the OK key.
Completed. is displayed and the screen returns to
the basic screen for scanning.
10 Specify the destination, and press the Start key to
start scanning.
Item Detail
Manual Adjust density using 7 levels.
Auto Optimum density is selected according to the density of the original.
Function Menu: a b
*********************
2 Original Size T
3
Original Image T
[ Exit ]
1 Color Selection T
Density: a b
1 Auto
*********************
2 *Manual