Kyocera FS-1024MFP

Basic Operation
OPERATION GUIDE 3-9
3
Adjusting Density
Use this procedure to adjust the density when copying.
NOTE: You may choose Auto mode as the default setting (refer to Density on page 8-38).
The procedure for adjusting the density of copies is explained below.
1 Press the Function Menu key. Function Menu
appears.
2 Press the U or V key to select [Density].
3 Press the OK key. Density appears.
4 Press the U or V key to select [Auto] or [Manual].
5 Press the OK key.
When [Manual] is selected, Manual appears. Press
the U or V key to select your desired density and
then press the OK key.
Completed. is displayed and the screen returns to
the basic screen.
6 Press the Start key. Copying begins.
NOTE: Press the Reset key to reset the settings
selected in Function Menu.
Density Adjustment Option Description
Manual Adjust density using 7 levels.
Auto Optimum density is selected according to the density of the original.
Function Menu: a b
*********************
2 Zoom T
3
Combine T
[ Exit ]
1 Collate T
Density: a b
1 Auto
*********************
2 *Manual
Manual: a b
3 v Lighter -1
*********************
5 y Darker +1
4 w Normal 0