Kyocera FS-1028MFP

Default Setting (System Menu)
OPERATION GUIDE 8-127
8
Network Setup
The following network settings are available.
• LAN Interface Setup …8-127
• TCP/IP (IPv4) Setup …8-128
• TCP/IP (IPv6) Setup …8-128
• NetWare Setup …8-129
• AppleTalk Setup …8-131
• Protocol Detail …8-134
LAN Interface Setup
Specify the settings for the LAN interface to be used. The default setting is Auto.
Use the procedure below to select the interface.
1 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and press the OK key.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in, and
press [Login] (the Right Select key).
2 The System menu appears.
3 Press the U or V key to select [Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the U or V key to select [LAN Interface].
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Login User Name: L b
*******************
Login Password:
[ Login ]
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 NetWare
3 AppleTalk
1 *TCP/IP Setting