Kyocera FS-1028MFP

Preparation before Use
OPERATION GUIDE 2-15
2
IMPORTANT: When the DHCP Setting (page 2-16) is
[On], the current Subnet Mask is displayed and cannot
be changed.
When setting an Subnet Mask, set the DHCP Setting
(page 2-16) to Off.
25 Press the OK key. Completed. is displayed and the
screen returns to the IPv4 Setting menu.
26 Press the U or V key to select [Default Gateway].
27 Press the OK key. Default Gateway appears.
28 Use the arrow keys to enter the Default Gateway.
Press the Y or Z key to move the cursor position
horizontally.
Press the U or V key or the numeric keys to enter
the Default Gateway. Each 3 digits can be set
between 000 and 255.
IMPORTANT: When the DHCP Setting (page 2-16) is
[On], the current Default Gateway is displayed and
cannot be changed.
When setting an Default Gateway, set the DHCP
Setting (page 2-16) to Off.
29 Press the OK key. Completed. is displayed and the
screen returns to the IPv4 Setting menu.
IPv4 Setting: a b
3 IP Address
4 Subnet Mask
*********************
[ Exit ]
5 Default Gateway
Default Gateway: a b
123.145.167.
189