Kyocera FS-1028MFP

Preparation before Use
2-20 OPERATION GUIDE
Completed. is displayed and the screen returns to
the IPv4 Setting menu.
AppleTalk Setup
Select the Apple Talk network connection. The default setting is On.
Use the procedure below to setup the AppleTalk setting.
1 Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in.
NOTE: Refer to Character Entry Method on Appendix-
5 for details on entering characters.
2 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and then press the OK key.
IMPORTANT: To make the settings, you must have
logged in using a user ID with administrator privileges.
If you have logged in using a user ID without
administrator privileges, the screen will display
Administrator only. and return to the standby screen.
3 In the System menu, press the U or V key to select
[Network Setting].
4 Press the OK key. The Network Setting menu
appears.
Login User Name: L b
********************
Login Password:
[ Menu ] [ Login ]
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Administrator only.
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 NetWare
3 AppleTalk
[ Exit ]
1 TCP/IP Settings