Sending Functions
OPERATION GUIDE 5-21
5
Job Finish Notice
This feature sends an e-mail providing notification that transmission has been completed.
Use the procedure below to specify the Job Finish Notice settings.
1 Press the Send key.
2 Place the originals on the platen.
3 Press the Function Menu key. Function Menu
appears.
4 Press the U or V key to select [JobFinish Notice].
5 Press the OK key. JobFinish Notice appears.
6 Press the U or V key to select [On] and then press
the OK key.
7 Press the U or V key to select [Address Book] or
[Address Entry], and then press the OK key.
8 If you select [Address Book], select [Address Book]
on the next screen and press the OK key, and then
select the notice destination.
Press [Menu] (the Right Select key), select [Detail]
on the next screen and press the OK key to view
the details of the selected notice destination.
If you select [Address Entry], enter the address of
the notice destination.
NOTE: Refer to Character Entry Method on Appendix-
5 for details on entering characters.
To Next Page
Loading...
