Kyocera FS-1028MFP

Preparation before Use
2-16 OPERATION GUIDE
DHCP Settings
Select whether or not to use the DHCP server. The default setting is On.
Use the procedure below to specify the DHCP setting.
1 Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the user ID and password to log in.
NOTE: Refer to Character Entry Method on Appendix-
5 for details on entering characters.
2 In the Sys. Menu/Count. menu, press the U or V
key to select [System], and then press the OK key.
IMPORTANT: To make the settings, you must have
logged in using a user ID with administrator privileges.
If you have logged in using a user ID without
administrator privileges, the screen will display
Administrator only. and return to the standby screen.
3 In the System menu, press the U or V key to select
[Network Setting].
4 Press the OK key. The Network Setting menu
appears.
5 Press the U or V key to select [TCP/IP Settings].
Login User Name: L b
********************
Login Password:
[ Login ]
Sys. Menu/Count.: a b
1 Report
2 Counter
*********************
[ Exit ]
3 System
Administrator only.
System: a b
*********************
2 I/F Block Set.
3 Security Level
[ Exit ]
1 Network Setting
Network Setting: a b
*********************
2 NetWare
3 AppleTalk
[ Exit ]
1 TCP/IP Settings