Operation Panel
4-100
2 Press [OK]. The SSL menu screen appears.
Off/On (SSL operation setting)
Select whether or not to use the SSL server. The default setting is Off.
1 In the SSL menu, press U or V to select Off/On.
2 Press [OK]. The Off/On screen appears.
3 Press U or V to select whether to use the SSL server.
4 Press [OK]. The SSL server setting is set and the SSL menu
reappears.
Encryption (Encryption setting)
Select the encryption method used on the SSL server.
1 In the SSL menu, press U or V to select Encryption.
2 Press [OK]. The Encryption screen appears.
3 Press U or V to select the encryption method to be used and then
press [OK].
The options available in Encryption are as follows:
• AES (SSL Server AES setting)
AES (Advanced Encryption Standard) was developed to replace
DES as the standard encryption as the safety of DES has declined.
AES is a block encryption system that uses 128-bit blocks and an
SPN structure (a typical structure for repeated encryption) with
three selectable key lengths of 128, 192 and 256 bits.
To Next Page
Loading...
Need help?
General
