Kyocera KM-1820 - Page 101

2GM
1-6-7
6. Remove the screw.
7. Remove the toner sensor and spring.
8. Remove two screws.
9. While pressing the latch by using the driver and then remove the MP feed unit.
Figure 1-6-8 Removing the MP feed unit
10. Remove the stop ring and then remove the MP feed roller.
Latch
Screw
Toner sensor
Spring
Screw
Screw
MP feed unit
Figure 1-6-9 Removing the MP feed roller
MP feed roller
Stop ring