Kyocera KM-1820 - Removing the Primary Circuit Pwbs; Removing the Engine PWB

2GM
1-6-9
1-6-7 Removing the primary circuit PWBs
(1) Removing the engine PWB
1. Remove the right cover (see page 1-6-4).
2. Remove all (twelve) connectors from the engine PWB.
3. Remove three screws.
4. Remove the engine PWB.
* When replacing the PWB with a new PWB,
remove the EEPROM from the old PWB and
mount it to the new PWB.
Figure 1-6-11 Removing the engine PWB
Screws
Engine PWB
EEPROM