Kyocera KM-1820 - U611 Setting System; Setting the Number of Adjustment Lines for Automatic Reduction; Setting the Number of Adjustment Lines for Automatic Reduction When A4 Paper Is Set; Setting the Number of Adjustment Lines for Automatic Reduction When Letter Size Paper Is Set

Maintenance
Description
item No.
3JG
1-3-8
U610
(cont.)
Increase the setting if a page received in the reduction mode is over-reduced and too much trailing edge
margin is left. Decrease it if the received image does not include all transmitted data.
2. Press the enter key. The value is set.
Completion
Press the back key. The screen for selecting a maintenance item No. is displayed.
U611 Setting system 2
Description
Sets the number of adjustment lines for automatic reduction.
Start
1. Press the enter key.
2. Select the item to be set using the up/down cursor keys.
Display Description
1: ADJ LINES Sets the number of adjustment lines for automatic reduction.
2: ADJ LINES (A4) Sets the number of adjustment lines for automatic reduction
when A4 paper is set.
3: ADJ LINES (LT) Sets the number of adjustment lines for automatic reduction
when letter size paper is set.
Setting the number of adjustment lines for automatic reduction
Sets the number of adjustment lines for automatic reduction.
1. Change the setting using the left/right cursor keys.
Description Setting range Initial setting
Number of adjustment lines for automatic reduction 0 to 22 7
2. Press the enter key. The value is set.
Setting the number of adjustment lines for automatic reduction when A4 paper is set
Sets the number of adjustment lines for automatic reduction when A4 paper is set.
1. Change the setting using the left/right cursor keys.
Description Setting range Initial setting
Number of adjustment lines for automatic reduction 0 to 22 22
when A4 paper is set
2. Press the enter key. The value is set.
Setting the number of adjustment lines for automatic reduction when letter size paper is set
Sets the number of adjustment lines for automatic reduction when letter size paper is set.
1. Change the setting using the left/right cursor keys.
Description Setting range Initial setting
Number of adjustment lines for automatic reduction 0 to 26 26
when letter size paper is set
2. Press the enter key. The value is set.
Completion
Press the back key. The screen for selecting a maintenance item No. is displayed.