3JG
1-4-2
(2) Table of general classification
Error code Description
U00000 No response or busy after the set number of redials.
U00100 Transmission was interrupted by a press of the stop/clear key.
U00200 Reception was interrupted by a press of the stop/clear key.
U00300 Recording paper on the destination unit has run out during transmission.
U004XX A connection was made but interrupted during handshake with the receiver unit (refer to page 1-
4-4 “U004XX error code table”).
U00500 Multiple communication was interrupted and call was not made on destination units after
interruption.
U006XX Communication was interrupted because of a machine problem (refer to page 1-4-5 “U006XX
error code table”).
U00700 Communication was interrupted because of a problem in the destination unit.
U008XX A page transmission error occurred in G3 mode (refer to page 1-4-5 “U008XX error code table”).
U009XX A page reception error occurred in G3 mode (refer to page 1-4-5 “U009XX error code table”).
U010XX Transmission in G3 mode was interrupted by a signal error (refer to page 1-4-6 “U010XX error
code table”).
U011XX Reception in G3 mode was interrupted by a signal error (refer to page 1-4-8 “U011XX error code
table”).
U01400 An invalid one-touch key was specified during communication.
U01500 A communication error occurred when calling in V.8 mode.
U01600 A communication error occurred when called in V.8 mode.
U017XX A communication error occurred before starting T.30 protocol during transmission in V.34 mode
(refer to page 1-4-10 “U017XX error code table”).
U018XX A communication error occurred before starting T.30 protocol during reception in V.34 mode
(refer to page 1-4-10 “U018XX error code table”).
U02000 Relay broadcast was refused by a relay station because of a mismatch in permit ID number and
permit telephone number when a relay command was issued.
U02100 A relay command failed because the destination unit (relay station) had no relay broadcast
capability.
U02200 A relay command from a command station failed because a telephone number that was not
registered in the relay station was specified. Or, relay broadcast was requested to a relay station
but failed because a telephone number that was not registered in the relay station was specified.
U023XX Receiving station information was not normally received in reception of a relay command (refer
to page 1-4-10 “U023XX error code table”).
U02400 An interoffice subaddress-based relay transmission was interrupted because of a mismatch in
the specified relay box number.
U03000 No document was present in the destination unit when polling reception started.
U03100 In reverse polling, although no original was set in the destination unit, transmission was
complete.
U03200 In confidential polling reception, data was not accumulated in the specified box in the destination
unit. Or, in interoffice subaddress-based bulletin board reception, data was not stored in the box
specified by the destination unit.
U03300 In polling reception from a unit of our make, operation was interrupted due to a mismatch in
permit ID or telephone number. Or, in interoffice subaddress-based bulletin board reception,
operation was interrupted due to a mismatch in permit ID or telephone number.
U03400 Polling reception was interrupted because of a mismatch in individual numbers (destination unit
is either of our make or by another manufacturer).
To Next Page
Loading...
