3-8
Sending Faxes > Methods For Entering the Destination
3
Select transmission settings.
Sub address communication, encrypted transmission, transmission start speed and ECM can
be set.
1 Select [Detail].
2 Select the item to change the settings for and then select [Edit] or [Change].
3 Select the [OK] key.
4
Select the [OK] key.
Entry of the destination finishes.
Key Description
Sub Address Set this to transmit using a Sub Address.
Sub Address Transmission (page 5-16)
Encrypted Transmission This is set when using encrypted transmission to send the
data.
Encryption (page 5-23)
TX Start Speed This is set to change the transmission start speed. Select the
speed from 33,600 bps, 14,400 bps, and 9,600 bps.
Normally this should be used with the default setting.
ECM ECM is a communication mode specified by the ITU-T
(International Telecommunication Union) that retransmits data
when an error occurs. Fax machines that have ECM mode
check for errors as they communicate, preventing distortion of
the image due to noise on the line and other conditions.
When [On] is selected in [Check New Dest.], a confirmation screen is displayed for the
entered FAX number. Re-enter the same FAX number and select [OK].
Machine’s Operation Guide
You can enter the next fax number.
Broadcast Transmission (page 3-11)
In addition to a fax, you can include e-mail transmission and folder (SMB/FTP) transmission
to send as one job.
Machine’s Operation Guide
To Next Page
Loading...
