Installing an inclinometer on A10-BUMP
Installing an inclinometer on A10-BUMP
Tools
• torque screwdriver
• T20 Torx bit
• 7 mm wrench
About this task
A10-BUMP is equipped with a support plate for installing an optional inclinometer. Three models are compatible:
TEQSAS
®
LAP-TEQ PLUS (provided in the TECH TOOLCASE), TEQSAS
®
LAP-TEQ (legacy model), and KSG
®
RECLINE
Compact.
LAP-TEQ / LAP-TEQ PLUS sensor and display compatibility
The legacy LAP-TEQ sensors are compatible with the new TEQSAS
®
LAP-TEQ PLUS displays.
Conversely, the new sensors are not compatible with the legacy displays.
With two sets of xation points and slit openings, the position and orientation of the laser support plate can be adapted
to every use of the rigging frame.
slit openings
fixation points (left)
fixation points (right)
Calibrating the inclinometer
Refer to the manufacturer instructions.
An additional XLR cable is needed.
Exploded view
Use the screws and nuts provided with A10-BUMP.
Before tightening the screws, align the laser with the slit opening.
T25
7 mm
3 N.m
A10 owner's manual (EN) version 1.1 141
To Next Page
Loading...
Need help?
General
