Labconco Purifier Logic+ 30241 - Initial Operation of the Logic+

Product Service 1-800-522-7658
58
Section Four -
Initial Operation of the Logic+
This section will take you through the steps to begin initial operation of the Logic+, with
an explanation the controls, display and options, in order to prepare the unit for its
initial certification.
System Reset Switch
The biosafety cabinet has a system reset switch for resetting its microprocessors. The
switch is located on the front of the electronics module, on top of the cabinet, as shown
in Figure 4-1. Ensure that the switch is in the “ON” (up) position before attempting to
operate the cabinet.
The System Reset
Switch
Figure 4-1