EasyManuals Logo

Labrie AUTOMIZER HELPING-HAND User Manual

Labrie AUTOMIZER HELPING-HAND
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #107 background imageLoading...
Page #107 background image
Operating the AUTOMIZER
TM
HELPING-HAND 97
Figure 4-10
A
UTOMIZER
TM
H
ELPING
-H
AND
automated collection
8. Lower back the cart to about 2 feet above the ground.
Ensure that the cart is empty before lowering the gripper.
9. Extend and lower the lifting arm to place the cart back to where it was.
10. Open the gripper to release the cart using the open gripper button on the joystick.
11. Fully retract the lifting arm to park it alongside the vehicle with the gripper wide open.
B. To load refuse into the hopper with the optional lifting bucket:
NOTE: The following procedure relates to the use of the Auto-Neutral feature and the temporary
handbrake. This applies only to cabs modified by Labrie Enviroquip Group. If your cab has not
been modified by Labrie Enviroquip Group, please refer to your cab manufacturer’s
recommendations.
1. On the control panel, turn on the Auto-Neutral switch (see Multiplexed Switch Actuators on
page 31).
Danger!
Never drive the AUTOMIZER
TM
HELPING-HAND with the lifting arm extended and/or the
gripper closed and popping out.
Warning!
Do not open the gripper while lifting up a roller cart because the cart will fall down. This
may result in equipment damage and/or injury.
6
7

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie AUTOMIZER HELPING-HAND and is the answer not in the manual?

Labrie AUTOMIZER HELPING-HAND Specifications

General IconGeneral
BrandLabrie
ModelAUTOMIZER HELPING-HAND
CategoryUtility Vehicle
LanguageEnglish

Related product manuals