EasyManuals Logo

Labrie AUTOMIZER HELPING-HAND User Manual

Labrie AUTOMIZER HELPING-HAND
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
84 Operating the AUTOMIZER
TM
HELPING-HAND
Visual Inspection
Before starting the vehicle, the operator MUST perform a visual inspection of the truck. Ensure the
engine is not running and the parking brake is set.
NOTE: Some of the items mentioned in this manual are optional and may not be found on your
AUTOMIZER
TM
HELPING-HAND.
As part of the visual inspection, you must:
Ensure the cleanliness of lamps, safety decals, camera lenses, mirrors, windows, and the vehicle in
general.
Ensure that safety equipment is available on board (i.e. fire extinguisher, first-aid kit).
Ensure there is no structural damage.
Ensure that there is no unusual wear, distortion, cracking, leaning, leaking on the vehicle.
Ensure that the hydraulic oil level (sight gauge on tank) is as recommended (cylinders must be
collapsed).
Ensure that the hydraulic cylinders do not leak and mounting pins are secure.
Ensure that the hydraulic tank shut-off valve is fully open.
Ensure there is no mechanical problem: structure, rollers, hinges, door locks, wear items, etc.
Report any defective system to maintenance personnel.
Ensure there are no leaks, cracks or other types of problems on the frame area, fuel tank, hydraulic
tank, air tanks (air tanks must be drained every day), cleaning trap and wheels.
Ensure that the tailgate is fully closed and BOTH tailgate safety pins are in place.
Once the visual inspection is over, you must start the engine to check if the systems are working
properly.
Starting the Vehicle
To start the AUTOMIZER
TM
HELPING-HAND:
1. Before starting the engine, check the following items:
1 a. Transmission shifter is on neutral.
1 b. Parking brake is on (see Parking Brake on page 79).
1 c. Hydraulic system is off (see Hydraulic Pump Switch on page 70).
2. Start the vehicle as stated in the chassis manufacturer’s manual.
3. Switch ON the pump to engage the hydraulic system (see Hydraulic Pump Switch on page 70).
Air pressure has to be at a minimum of 70 PSI.
4. Turn ON all light switches.
5. If required, move the truck to an appropriate area to perform the daily inspection.
6. Report any defective system to the maintenance personnel.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie AUTOMIZER HELPING-HAND and is the answer not in the manual?

Labrie AUTOMIZER HELPING-HAND Specifications

General IconGeneral
BrandLabrie
ModelAUTOMIZER HELPING-HAND
CategoryUtility Vehicle
LanguageEnglish

Related product manuals