Introduction 5
Figure 1-6
Inside the A
UTOMIZER
TM
H
ELPING
-H
AND
cab
Key Features of the AUTOMIZER
TM
HELPING-HAND
The AUTOMIZER
TM
HELPING-HAND comes with a series of key features, such as:
Body roof and sides made of A1011 GR80 steel, body floor and hopper section made of 100%
Hardox 450 steel, delivering ultimate strength at the lowest possible body weight
Hardox liners on floor and sides (optional)
10-foot arm extension
Arm lifting capacity at full extension: 400 lbs
Reinforced body walls
Tapered body
Oversized clean-out doors on both sides of the truck
Multiplexed control system with on-board diagnostic tool
Multiplexed System
The AUTOMIZER
TM
HELPING-HAND is equipped with an electronic monitoring system called the
Multiplexed System.
The Multiplexed system used by Labrie is a CAN-based system that integrates a monitor, a control
panel and a number of electronic modules. This whole system has been designed to help you operate
your unit in an efficient and easy way. See Labrie’s Multiplexed System on page 49 for more details.
IMPORTANT: AUTOMIZER
TM
HELPING-HAND units must be operated by only one person.