EasyManuals Logo

Labrie AUTOMIZER HELPING-HAND User Manual

Labrie AUTOMIZER HELPING-HAND
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #110 background imageLoading...
Page #110 background image
100 Operating the AUTOMIZER
TM
HELPING-HAND
The multi-cycle function allows the packer to perform up to 8 cycles when pressing the start cycle
button (green button). Standard factory preset of the module is 3 cycles.
Unloading
Unloading Procedure
Once you have completed your collection route, park the lifting arm or the bucket inside the hopper
(the crusher panel [if installed] must be in the up position). Keep some garbage not packed in front
of the packer in order to facilitate the unloading process.
The following is the standard unloading procedure:
1. Drive the vehicle to the landfill.
2. Ensure the vehicle is on safe, stable and level ground.
3. Check the overhead clearance before opening the tailgate and raising the body.
Make sure the air suspension is dropped or the tag axle is down (if equipped).
4. Remove both tailgate safety pins.
Figure 4-14
Safety pin
Warning!
Ensure the overhead is clear before raising the body.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie AUTOMIZER HELPING-HAND and is the answer not in the manual?

Labrie AUTOMIZER HELPING-HAND Specifications

General IconGeneral
BrandLabrie
ModelAUTOMIZER HELPING-HAND
CategoryUtility Vehicle
LanguageEnglish

Related product manuals