Operating the AUTOMIZER
TM
HELPING-HAND 105
Figure 4-17
Clean-out door (left) and hoe (right)
9. Finish cleaning the area with pressurized water.
Daily Chassis Cleaning
The following is the daily chassis cleaning procedure:
1. Start the engine.
2. Engage the hydraulic pump by pressing the Pump switch on the control panel.
The switch turns green.
3. Using the Body Up switch on the control panel, raise the body until the safety prop is free to tilt
under the body.
4. Release the safety prop using the prop release handle (see Figure 4-16).
5. Pull down the safety prop towards the body.
6. Slowly lower the body until it rests on the prop using the Body Down switch on the control panel.
7. Turn OFF the pump and the truck engine.
8. Apply the lockout/tagout procedure (see Locking Out and Tagging Out the Vehicle on page 43).
9. Clean with pressurized water between the body and the frame.
10. Clean the rear of the cab.
11. Perform a visual inspection for leaks or wear in this area.
12. When finished, start the engine and reengage the hydraulic pump.
13. Raise the body just enough to bring the safety prop back to its vertical position, then lower the
body until it rests on the frame.
14. Turn OFF the pump and the truck engine.
15. Clean the body all around with water and soap.
16. Rinse.