EasyManuals Logo

laerdal SimNewB Directions For Use

laerdal SimNewB
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Manikin connectors
The SimNewB™ manikin is shipped ready for use. It must be connected to the SimNewB Control Unit and the
Compact Compressor Unit to function.
The manikin’s control cable and tube bundle has the following connectors:
Setting up the SimNewB Neonatal Simulator system
Check that the Control Unit and Remote Control have batteries and that any battery protection tape inside the battery
case (when new) is removed. The Control Unit can also be connected to external power using the DC Power Supply.
1 - Connect the Manikin cable to the Control Unit and the Manikin connector.
2 - Connect the Blood pressure extension tube to the Control Unit BP connector and the Manikin Blood Pressure
connector.
3 - Connect the Air/CO
2
double-lumen tube to the Compressor Unit and the Manikin Air/CO
2
connector.
4 - Switch the Control Unit and the Remote Control on.
5 - Switch the Compressor Unit on, as described on page 7.
6 - Connect the Blood Pressure Cuffs connector to the Manikin Blood Pressure Cuff Connector. The BP cuff may be
wrapped around the right upper arm.
7 - Connect the empty IV-bag set to the Umbilical Reservoir Overflow tube.
Note - The overflow tube has a valve to prevent leakage from the tube when not attached to IV-bag set.
NOTE: For set up and assembly of the SimNewB ADVANCED, please see the SimNewB Advanced system installation guide. This is a
trifold brochure shipped with your manikin.
8
INTRODUCTION
CLINICAL
SIMULATION
REMOTE
CONTROL PC UTILITIES
DETAIL
SPECIFICATIONS
TROUBLE-
SHOOTING
SETUP GUIDE
B
E
C
A
F
G
H
A - Blood Pressure Cuff connector
B - Manikin connector
C - Manikin Blood Pressure con-
nector (to Control Unit)
D - Air exhaust tube (no con-
nections)
E - Manikin Air/CO
2
connector
F - Umbilical Reservoir Overflow
tube
Extension cables are used to con-
nect the manikin to the Control
Unit and the Compressor Unit.
G - Manikin cable with Blood
Pressure tube (from Manikin
Connector and Manikin Blood
Pressure connector to Control
Unit)
H - Air/CO
2
tube (from Manikin
Air/CO
2
connector to
Compressor Unit)
D
SimNewB.qxp:SimNewB DFU EN 3/25/08 4:23 PM Page 8

Other manuals for laerdal SimNewB

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the laerdal SimNewB and is the answer not in the manual?

laerdal SimNewB Specifications

General IconGeneral
Brandlaerdal
ModelSimNewB
CategoryMedical Equipment
LanguageEnglish

Related product manuals