6
INTRODUCTION
CLINICAL
SIMULATION
REMOTE
CONTROL PC UTILITIES
DETAIL
SPECIFICATIONS
TROUBLE-
SHOOTING
Battery insertion or change
Remote Control
The battery status in the Remote Control is indicated in the
upper right corner of the display. Batteries should be replaced
immediately when battery empty is indicated.
When the battery is totally empty, the Remote Control will
turn itself off without any warning.
Replace the Remote Control batteries with 4 AA size alkaline
batteries.
Control Unit
When the battery for the Control Unit has reached a state
where less than 20% capacity remains, a “Battery low” message
will be displayed by the Remote Control.
When the remaining capacity in the Control Unit battery is less
than 10%, a “Replace battery” warning will by given on the
Remote Control, and the indicator light in the Control Unit will
be flashing alternating between red and green.
When the battery is totally empty, the Control Unit will turn it-
self off without any warning.
Replace the batteries in the Control Unit battery case with 6
C-cell alkaline batteries.
When the Control Unit is connected to the DC power supply,
the Control Unit does not need batteries. No battery low mes-
sage will be given when the DC power supply is used, even
though the batteries may be empty.
SETUP GUIDE
To Next Page
Loading...
Need help?
General
