laerdal SimNewB - Overview of Compact Compressor Unit

7
ENGLISH
INTRODUCTION
CLINICAL
SIMULATION
REMOTE
CONTROL PC UTILITIES
DETAIL
SPECIFICATIONS
TROUBLE-
SHOOTING
SETUP GUIDE
2
Operation of Compact Compressor unit
The Compact Compressor provides air for the SimNewB™
manikin’s breathing, movements and pulses, and CO
2
to be mixed
into the manikin’s expired air.
Setup procedure:
1) See the instructions for use and labeling provided with the
compressor.
2) Check that Power switch (1) is set to OFF position.
3) Plug power supply cable into plug (4).
4) Plug power supply cable into power source.
5) Connect the Air/CO
2
tube to the Output to Manikin
connector (2).
Optional - this is not required for operation:
6) Connect the CO
2
regulator to a suitable CO
2
tank.
7) Connect the blue CO
2
tube between the CO
2
regulator and
the Input CO
2
connector (3) at the back of the compressor.
Compresor start:
Press Power switch (1) to ON position.
The compressor will run continuously when turned on.
Compressor stop:
Press Power switch (1) to OFF position.
The compressor will stop and vent automatically.
Warning:
Do not open Compressor housing. Dangerous voltage inside. Only to be
opened by authorized personnel.
1
Front side:
Back side:
3
4
SimNewB.qxp:SimNewB DFU EN 3/25/08 4:23 PM Page 7