FLAPS_V6_HBR_datasheet_manual_EN.odt
Repeat this sequence described above for all positions you want to program or tune.
IMPORTANT NOTE: If you are reprogramming the sequence of target positions
mirrored to the factory preset target positions (newly position 0 corresponds to
the actuator retracted), Programmed Position Error will be displayed as soon as
the first edited target position is stored on the opposite end of the piston rod
path. This is NOT a problem! The control unit checks that the positions of the
individual target positions are consecutive. Proceed further by programming
NEXT target positions. After reprogramming the last of the target positions, the
Programmed Position Errors disappear (of course if the target positions are
consecutive and do not overlap).
ATTENTION! The positions of the target positions must not be thrown over or
overlap (distance > 2mm movement of the piston rod). The device checks this
condition and reports Programmed Position Error if it is not observed.
Compliance with this condition is essential for proper operation of the device.
ATTENTION! If the supply voltage is lost during the Position Programming
Mode, changes to the currently programmed target position are not saved! and
the next time the device is turned on, it will run at its original settings.
ATTENTION! Avoid losing power while saving settings (alternating blinking of
corresponding orange / green LED - data could be stored incorrectly or even
damaged)
27/33
To Next Page
Loading...
Need help?
General