LAMBERT FLAPS V6 HBR (3P) User Manual

FLAPS_V6_HBR_datasheet_manual_EN.odt
6.2 Troubleshooting
The most common faults and their elimination are dealt with in Chapter 6.1 Indicated
errors and faults, where the causes and possible remedies of the indicated errors and
faults are listed in the table.
However, if you do not find a solution to your fault in the that chapter, try to find the
solution in the following table:
Fault description Possible causes Solutions
The actuator does not reach
the limit switch
•
Unwanted mechanical shift
of the external limit switch
•
Poor programming of the
position – not
Acknowledged travel to
the limit switch
•
Check the mechanical
attachment of the limit
switch
•
reprogram (according to
the relevant chapter of
this manual) the target
position with the limit
switch
NOTE This chapter is gradually supplemented based on product experience and customer
inquiries.
32/33

LAMBERT FLAPS V6 HBR (3P) Specifications

General

Brand	LAMBERT
Model	FLAPS V6 HBR (3P)
Category	Control Unit
Language	English