FLAPS_V6_HBR_datasheet_manual_EN.odt
1 Important notes and warnings
Thank you for purchasing FLAPS V6 HBR. For a comfortable and safe use of this product,
please pay attention to THE ENTIRE MANUAL, especially the notes and warnings below.
• Although the FLAPS V6 HBR control unit has been thoroughly tested to ensure
maximum safety in all conceivable situations, THE RIGHT FUNCTIONALITY
DEPENDS ON THE RIGHT INSTALLATION AND SETTINGS.
• Therefore, it is NECESSARY to READ CAREFULLY and UNDERSTAND THIS
MANUAL COMPLETELY.
• Keep this manual printed in an airplane for cases of emergency or change of
ownership.
• THIS PRODUCT IS NOT APPROVED FOR INSTALLING IN CERTIFIED AIRPLANES.
• The pilot MUST UNDERSTAND the control of this product before the first flight. DO
NOT use the product unless you are sure how it works!
• Do not allow unauthorized persons to handle the installed product.
• After installing the product, before the first flight, turn on ALL possible sources of
electromagnetic interference on board the aircraft and ensure that the instrument is
functioning properly.
• Use of the device in conflict with this manual, with bad wiring, outside the allowed
operating conditions, etc., may cause the device to malfunction or damage and
endanger flight safety.
• If the product repeatedly indicates an error, do not use it and turn off the power!
(except for switching to safety manual mode in the event of a position sensor error
where the position of the flaps can be manually controlled)
• AVOID contact with liquids and chemicals
• Before installation, check the mechanical integrity of the device and its accessories
• DO NOT disassemble the device!
• After installation, carefully check the functionality of the device and its installation
• The responsibility for the installation is entirely with the installer.
• Responsibility for performed control actions is fully with the operator (pilot).
• If you do not agree to the notes and warnings above, do not use this product.
Company LAMBERT ELECTRONIC s.r.o. reserves the right to change, improve the product
or manual without prior or subsequent notice.
5/33