Lantronix EDS4100 User Manual

A: Configuration Using Telnet or Serial Port
EDS4100 4 Port Device Server User Guide 152
Tunnel Menu Command Description
connect aes encryption
key <string>
Sets the AES encryption key using ASCII format.
<string> = AES encryption key to be set.
connect aes encryption
key binary <string>
Sets the AES encryption key using binary format.
<string> = AES encryption key to be set.
connect always
Enables connect mode.
connect any character
Enable connect mode when a character is received.
connect block network
Blocks the tunneling of serial data.
connect dsr active
Enables connect mode if the Data Set Ready (DSR) signal
is asserted.
connect flush serial data
Flushes the serial data buffer on a connection.
connect keep alive
<number>
Enables TCP keepalives and the sets timer in
milliseconds.
<number> = number of milliseconds to which the timer is
set.
connect modem control
active
Enable Connect mode when the modem control pin is set
to asserted.
connect modem emulation
Enables modem emulation.
connect port <number>
Sets the specific port to use as the local port.
<number> = number of the port to be used as the local
port.
connect protocol ssh
Uses SSH for connect mode.
connect protocol tcp
Uses TCP for connect mode.
connect protocol tcp aes
Uses AES over TCP for connect mode.
connect protocol udp
Uses UDP for connect mode.
connect protocol udp aes
Uses AES over UDP for connect mode.
connect reconnect timer
<milliseconds>
Sets the reconnect time value in milliseconds.
<milliseconds> = number of milliseconds.
connect remote <host>
Set the remote address in which to connect.
<host> = host IP address.
connect remote port
<number>
Sets remote port
<number> = port number of remote port.

Lantronix EDS4100 Specifications

General

Brand	Lantronix
Model	EDS4100
Category	Server
Language	English