HVM200 Reference Manual Turning Off/On WiFi Signal 4-4
FIGURE 4-6 WiFi Setup
Step 4 Click on the power button.
FIGURE 4-7 Network Settings
Step 5 An Alert will appear. Select Confirm. WiFi is now disabled.
4.3.2 Turn Back On WiFi Signal
To turn the WiFi signal back on from the HVM200 meter, follow these
steps:
Step 1 Connect HVM200 via USB cable to PC, launch G4 LD Util-
ity and connect meter, see “Connecting HVM200 to G4 LD
Utility” on page 2-8.
Step 2 From the Setup WiFi screen, click the red power symbol in
the upper left side
FIGURE 4-8 Network Settings
Step 3 An Alert will appear, click Confirm.
Step 4 A reboot is required to turn the WiFi back on, so you can
select the Reboot button or manually turn off the meter
To Next Page
Loading...
