Laser Mech FiberMINI 2.0

Questions and Answers

M
Marie RobertsAug 4, 2025
Why is the V output unstable or HSU noisy in my Laser Mech Industrial Equipment?
- S
  scolemanAug 4, 2025
  If the V Output of your Laser Mech Industrial Equipment is unstable or the HSU is noisy, it could be due to several reasons. The power supply to the height sensor might be noisy, so ensure you're using a well-regulated DC power supply. External electrical interference can also cause this, so move the control electronics away from motors and high-voltage wires. Finally, check your grounding; ensure the part and cutting head are properly grounded, and consider using a separate copper grounding rod.
A
Amy KingAug 14, 2025
How to troubleshoot no signal on V HSU Output on Laser Mech FiberMINI 2.0?
- E
  Elizabeth YoungAug 15, 2025
  If there's no signal on the V HSU Output of your Laser Mech Industrial Equipment, start by checking that the correct power is applied to TB1. Also, ensure the tip is fully insulated from ground and the cutting head body; replace the white sense cable or nozzle assembly and check for debris causing a short. Finally, inspect the wiring from TB2 to ensure the V Output signal isn't shorted or open.
J
Joshua CollinsAug 25, 2025
Why does Ready Signal remain off and HSU Utility indicates Cable Break on Laser Mech FiberMINI 2.0 Industrial Equipment?
- M
  Mark SmallAug 25, 2025
  If the Ready Signal remains off and the Basic+ HSU Utility indicates Cable Break on your Laser Mech Industrial Equipment, inspect the sense cable and tip retaining assembly (nozzle). This fault often arises from bad or intermittent connections. Recalibrate to clear the fault.

Laser Mech FiberMINI 2.0 Specifications

General

Weight	Unknown
Laser Type	Fiber Laser
Wavelength	1070 nm
Cooling Method	Water
Operating Voltage	24 VDC
Control Interface	EtherCAT
Software Compatibility	Proprietary Laser Mech software

Laser Mech FiberMINI 2.0 - User Manual

Table of Contents

Questions and Answers

Laser Mech FiberMINI 2.0 Specifications