Leetro MPC6575 User Manual

MPC6575-Close-loop Laser Engraving &Cutting Controller (Rev. 1.0)
10
CUT BDR: Laser head will move a rectangle with laser on according to the size of the graphics.
LAS SET: Select this option and press . The LAS SET interface is as follows.
Press or can move the cursor.
Press or can change the number.
Press
and all the number will be saved.
If the value is 0, press Laser and laser will be on; loosen the button and laser will be off.
If the value is not 0, press Laser and laser will shoot a certain time as set by the user.
PMOV SET: Select this option and press
. The PMOV SET interface is as follows.
Press or to adjust the value.
Press
to save the setting.
If this value is 0, press to move the laser head, and loosen the buttons to stop
the laser head.
If this value is not 0, press to move the laser head a certain distance as set
by the user.
LANGUAGE: Select this option and press
. The language interface is as follows.
Select the language as you prefer.
LAS SET
PMOV SET
LANGUAGE
CUT BDR
LASER TIME SET
MS
POWER SET
%
000000
DISTANCE SET
MM
简体中文
繁体中文
ENGLISH
000000
000000

Leetro MPC6575 Specifications

General

Brand	Leetro
Model	MPC6575
Category	Controller
Language	English